Directions also available in: Spanish - Canadian French


READ INSTRUCTIONS COMPLETELY
BLADES WILL REPLACE THOSE ON MOST 42" TO 52" CEILING FANS

Tools required: Drill, appropriate size drill bit, and screwdriver.


1. Turn off power to fan, Remove old blades by detaching the blade arms from motor with screwdriver. Careful not to misplace screws or other necessary parts.

2. Remove fan blades from arms. Careful not to misplace screws or other necessary parts. Use one of the old blades as a guide, you may want to clean it a bit. .

3. With design side faceing you, place your old blade on top of your designer blade, making sure the two blades are Aligned and Centered from top to bottom. Paying special attention if old blade is wider than designer blade. ** Failure to do so may cause fan to wobble.

4. Insert a sharp pencil through the holes of your old blade and mark the points where holes will be in your designer blades. Make sure blades are Aligned and Centered when marking. Repeat this step for all blades. .

5. Choose a drill bit that will make the same size holes as the ones in your old blade. Discard old blade. Where you have marked, drill straight holes through designer blade. Repeat this step for all blades. Now reattach blades to arms securely, then arms to motor securely and turn fan on.

*** To clean, wipe gently with damp cloth and mild liquid soap, blot dry with towel. Do Not Immerse In Water.



Should you have questions call Helpline toll free at 1-877-882- 3996
Outside the U.S. call direct at 1-517-882-3996 .